Frigidaire Side By Side Refrigerator Freezer Not Freezing


Frigidaire Side By Side Refrigerator Freezer Not Freezing

Introduction

A Frigidaire side-by-side refrigerator freezer that isn’t freezing properly can be a major headache. It can lead to food spoilage, wasted money, and unnecessary trips to the grocery store. This problem often manifests when you notice ice cream melting, food feeling soft instead of frozen, or the freezer temperature alarm going off. Addressing this issue promptly is important to prevent food waste and ensure your family’s food safety.

💡 Technical Key Takeaways:

  • Core Focus: Diagnostic schematic and terminal connection layout for Frigidaire Side By Side Refrigerator Freezer Not Freezing.
  • Target Scope: Field technicians, automotive DIYers, and residential/commercial electricians.
  • Safety Rule: Always disconnect the primary power source/battery terminal and verify zero voltage with a multimeter before touching wires.

Common Causes of frigidaire side by side refrigerator freezer not freezing

  • Dirty Condenser Coils: Dust and debris on the condenser coils hinder heat dissipation, making the freezer work harder and less efficiently.
  • Blocked Vents: Items blocking the vents inside the freezer restrict airflow, preventing cold air from circulating properly.
  • Faulty Door Seal: A damaged or dirty door seal allows warm air to enter the freezer, raising the temperature and impairing freezing.
  • Incorrect Temperature Settings: Sometimes, the temperature settings are accidentally adjusted too high, preventing the freezer from reaching optimal freezing temperatures.
  • Overloaded Freezer: Packing the freezer too full restricts airflow and can lead to uneven freezing.
  • Defrost System Problems: A malfunctioning defrost system can cause ice to build up, insulating the freezer and reducing its cooling capacity.
  • Faulty Start Relay: This component helps start the compressor, and if it is faulty, the compressor may not run properly.
  • Damaged Evaporator Fan Motor: The evaporator fan circulates cold air within the freezer, and if it fails, freezing will be compromised.

Symptoms Checklist

  • Freezer temperature above the set point.
  • Food items are soft or partially thawed.
  • Ice cream is melting.
  • Freezer alarm is sounding.
  • Excessive frost buildup inside the freezer.
  • The refrigerator is working fine, but the freezer is not.
  • You hear the refrigerator running, but it doesn’t seem as cold as it should be.

How to Fix frigidaire side by side refrigerator freezer not freezing Step-by-Step Guide

  1. Check Temperature Settings: Ensure the freezer temperature is set to the recommended setting (typically around 0F or -18C).
  2. Inspect Door Seal: Examine the door seal for any damage, tears, or gaps. Clean the seal with warm, soapy water and dry thoroughly.
  3. Clean Condenser Coils: Locate the condenser coils (usually on the back or bottom of the refrigerator) and clean them with a vacuum cleaner brush attachment.
  4. Clear Air Vents: Make sure that air vents inside the freezer are not blocked by food items. Rearrange items to allow for proper airflow.
  5. Defrost the Freezer Manually: If there’s excessive frost buildup, manually defrost the freezer. Unplug the refrigerator and let the ice melt. Use a towel to absorb the water.
  6. Check the Evaporator Fan: Open the freezer and listen for the evaporator fan. If you don’t hear it running, it may be faulty. (Requires disassembling the back panel inside the freezer proceed with caution.)
  7. Examine the Defrost Drain: Ensure the defrost drain is not clogged with ice or debris. A clogged drain can cause water to accumulate and refreeze, hindering the defrost system. You can use a turkey baster with warm water to try unclogging the drain.
  8. Check the Start Relay: The start relay is attached to the compressor. A faulty relay can prevent the compressor from running properly. (Requires accessing the back of the refrigerator and possibly using a multimeter.)
  9. Listen to the Compressor: Listen for the compressor. It’s located on the back of the refrigerator. It should be running. If not, the unit will not get cold.
  10. Avoid Overloading: Ensure that the freezer isn’t overpacked. Overcrowding restricts airflow and reduces freezing efficiency.
  11. Inspect the drain pan: Remove the bottom panel of the back side of the unit. Check if drain pan is full of water that doesn’t evaporate.

Fix the Issue Without Buying Parts

  • Reset the Refrigerator: Unplug the refrigerator for 5-10 minutes, then plug it back in. This can sometimes reset the control board and resolve minor issues.
  • Thorough Cleaning: Clean the interior of the freezer and refrigerator with a mixture of baking soda and water to remove any odors or residue.
  • Maintenance Basics: Schedule regular cleaning of the condenser coils (every 6 months) and check the door seals frequently.

When Replacement Might Be Necessary

If the steps above don’t resolve the issue, it might be necessary to consider replacing certain parts. Common components that fail include the evaporator fan motor (estimated cost: $50-$150 USD), the defrost heater ($30-$80 USD), or the defrost timer/control board ($50-$200 USD). If the compressor is failing, it might be more cost-effective to replace the entire refrigerator, as compressor repairs can be expensive (ranging from $300 to $800 USD). For more related activities, check out our Gasmate Bar Fridge Not Cooling.

Safety Warning

  • Always unplug the refrigerator before performing any repairs or cleaning.
  • Avoid working on electrical components if you’re not comfortable or experienced.
  • Be careful when handling sharp tools.
  • Ensure the floor is dry to prevent electric shock.
  • Never try to force parts or wires.

Tools You May Need

  • Screwdrivers (Phillips and flathead)
  • Vacuum cleaner with brush attachment
  • Warm water and mild detergent
  • Towels
  • Socket set
  • Multimeter (optional, for testing electrical components)

FAQ

  • Q: How often should I clean the condenser coils? A: Ideally, clean the condenser coils every 6 months to maintain optimal performance.
  • Q: Why is my freezer freezing on the bottom but not on the top? A: This is often due to blocked air vents or an overloaded freezer. Ensure proper airflow throughout the freezer.
  • Q: How do I know if my door seal is bad? A: Close the door on a dollar bill. If you can easily pull the bill out, the seal may be compromised.
  • Q: What temperature should I set my freezer to? A: Set your freezer to 0F (-18C) for optimal freezing and food preservation.
  • Q: Why is my refrigerator making a lot of noise? A: Excessive noise could indicate a problem with the condenser fan, evaporator fan, or compressor.

Conclusion

Troubleshooting a Frigidaire side-by-side freezer that’s not freezing can seem daunting, but by following these steps, you can often diagnose and fix the problem yourself. Remember to prioritize safety and take your time. If you’ve tried these steps and the freezer still isn’t working, it might be time to consult a qualified appliance repair technician.

Youtube Video:


Quick Wiring Specifications & Terminal Guide

Component / Circuit Standard Wire Gauge Recommended Protection
Control & Trigger Signals 18 – 20 AWG 5A – 7.5A Inline Fuse
Standard Auxiliary Load 14 – 16 AWG 15A – 20A Circuit Breaker
Main Power Feed / Supply 10 – 12 AWG 30A – 40A Heavy-Duty Relay

Images References


Images References, Refrigerator Problems 3

Looking for more diagnostic guides? Explore our complete Refrigerator Problems 3 section for step-by-step troubleshooting solutions.

📚 Related Articles

Scroll to Top