Ac Not Coming On Outside


Ac Not Coming On Outside

Introduction

When your air conditioner isn’t working correctly, especially the outdoor unit (also called the condenser), it can quickly turn your home into a sauna. “AC not coming on outside” is a common issue that means the outdoor part of your AC system isn’t starting up. This could be due to a simple problem, or a more complex electrical fault. Getting it sorted quickly is crucial to prevent discomfort and potential damage to your AC unit, especially during hot weather.

💡 Technical Key Takeaways:

  • Core Focus: Diagnostic schematic and terminal connection layout for Ac Not Coming On Outside.
  • Target Scope: Field technicians, automotive DIYers, and residential/commercial electricians.
  • Safety Rule: Always disconnect the primary power source/battery terminal and verify zero voltage with a multimeter before touching wires.

Common Causes of AC Not Coming On Outside

Here are some common reasons why your outdoor AC unit might not be turning on:

  • Tripped Breaker: An overloaded circuit can trip the breaker that powers your AC.
  • Dirty Air Filter: A clogged filter restricts airflow, causing the system to overheat and shut down.
  • Dirty Condenser Coils: Dirt and debris on the coils prevent proper heat exchange.
  • Faulty Capacitor: Capacitors provide the jolt needed to start the motor. A bad capacitor is a frequent culprit.
  • Frozen Evaporator Coil: Ice buildup restricts airflow and can damage the system.
  • Bad Contactor: The contactor is a switch that sends power to the outdoor unit.
  • Wiring Issues: Loose or corroded wires can interrupt the electrical flow.
  • Thermostat Problems: Incorrect settings or a faulty thermostat can prevent the outdoor unit from turning on.
  • Refrigerant Leak: Low refrigerant levels can cause the compressor to overheat and shut down.
  • Overload Protector: The unit might have an overload protector that senses an unsafe voltage or temperature and trips the unit off.

Symptoms Checklist

Use this checklist to identify the problem accurately:

  • The indoor fan is running, but the outdoor unit is silent.
  • No sound or vibration coming from the outdoor unit.
  • You hear a humming sound from the outdoor unit, but the fan doesn’t start.
  • The breaker for the AC trips frequently.
  • The air coming from the vents is not cold.
  • Ice is visible on the copper lines connected to the outdoor unit.
  • The outdoor unit turns on briefly then shuts off.

How to Fix AC Not Coming On Outside Step-by-Step Guide

Follow these steps to troubleshoot the problem:

  1. Check the Thermostat: Ensure the thermostat is set to “cool” and the temperature is set lower than the current room temperature.
  2. Inspect the Breaker: Locate the breaker for your AC unit in the electrical panel. If it’s tripped (in the “off” or middle position), reset it by flipping it fully “off” and then back “on”.
  3. Replace the Air Filter: A dirty air filter restricts airflow. Replace it with a clean filter of the correct size.
  4. Check the Disconnect Switch: Near the outdoor unit, there’s usually a disconnect switch. Make sure it’s in the “on” position.
  5. Inspect the Condenser Coils: Use a garden hose (with a gentle spray nozzle) to clean the condenser coils. Turn off the power to the unit first! Spray from the inside out to remove dirt and debris.
  6. Check for Ice: Look for ice buildup on the copper lines or the evaporator coil (located inside the indoor unit). If you see ice, turn off the AC and allow it to thaw for several hours.
  7. Inspect Wiring: Turn off power. Check for loose or corroded wires near the outdoor unit and at the disconnect switch. Tighten any loose connections and clean corroded areas with a wire brush.
  8. Listen for Humming: If you hear a humming sound but the fan isn’t spinning, the capacitor might be faulty. (Warning: Capacitors store electricity. Proceed with caution and preferably call a technician)..
  9. Check the overload switch: There might be a reset button to start the unit back up. If the temperature is too hot, or voltage is too low it may trip again.
  10. Look for Obvious Damage: Check for any signs of physical damage to the unit, such as bent fan blades or leaks.
  11. Check the contactor: After removing the panel, gently press the contactor inward with an insulated screwdriver. If it engages and the fan starts, replace the contactor.
  12. Document the Steps: Keep record of all troubleshooting steps, in order, so you can provide a qualified technician with as much information as possible.
  13. Power Cycle The System: Turn off the AC unit by turning off the breaker at the circuit breaker panel for 30 minutes. This allows the system to fully reset. Then, turn the breaker back on and test the AC again.

Fix the Issue Without Buying Parts

Many AC problems can be resolved without spending money on new parts:

  • Reset the Breaker: Sometimes a breaker trips due to a temporary power surge. Resetting it can fix the problem.
  • Clean the Condenser Coils: Regular cleaning improves efficiency and prevents overheating.
  • Replace the Air Filter: A clean filter is essential for proper airflow.
  • Thaw Frozen Coils: Turn off the AC and allow the ice to melt completely. Then, address the underlying cause (e.g., dirty filter).
  • Inspect and Tighten Connections: Loose wiring can cause problems. Regularly check and tighten connections.

When Replacement Might Be Necessary

In some cases, component replacement is unavoidable. Here are some signs that a part needs replacing:

  • Faulty Capacitor: Typically costs $50-$200 to replace.
  • Bad Contactor: Replacement costs range from $30-$150.
  • Failed Compressor: Replacing the compressor is expensive ($800-$2500) and might not be worth it for older units.
  • Refrigerant Leaks: Leaks require professional repair and refrigerant recharge. Costs vary depending on the severity of the leak.

Safety Warning

Follow these safety precautions:

  • Always turn off the power to the AC unit at the breaker before performing any maintenance or repairs.
  • Avoid working on electrical components if you’re not comfortable with electricity. Call a qualified technician.
  • Be careful when using water near electrical components.
  • Never touch the capacitor with your bare hands. Capacitors store electricity even when the unit is off.

Tools You May Need

Here’s a list of tools that might be helpful:

  • Screwdriver (Phillips and flathead)
  • Wrench
  • Wire brush
  • Garden hose with spray nozzle
  • Multimeter (for testing electrical components)
  • Insulated Screwdriver

FAQ

Here are some frequently asked questions:

  • Q: Why is my AC running but not cooling? A: Possible causes include a dirty air filter, frozen evaporator coil, or low refrigerant.
  • Q: How often should I clean my AC coils? A: At least once a year, or more often if you live in a dusty environment.
  • Q: How do I know if my capacitor is bad? A: Common symptoms include a humming sound, the fan not starting, or the unit turning on and off repeatedly.
  • Q: What should I do if I see ice on my AC unit? A: Turn off the AC and allow the ice to thaw completely. Then, address the underlying cause (e.g., dirty filter, low refrigerant).
  • Q: How do I reset my AC unit? A: Turn off the breaker at the electrical panel for 30 seconds, then turn it back on.

Conclusion

Troubleshooting “AC not coming on outside” can seem daunting, but by following these steps, you can often identify and resolve the problem yourself. Remember to prioritize safety and take your time. If you’re uncomfortable with any of these steps, or if the problem persists, don’t hesitate to call a qualified HVAC technician. They have the expertise and tools to diagnose and repair more complex issues. You’ve got this!

Youtube Video:


Quick Wiring Specifications & Terminal Guide

Component / Circuit Standard Wire Gauge Recommended Protection
Control & Trigger Signals 18 – 20 AWG 5A – 7.5A Inline Fuse
Standard Auxiliary Load 14 – 16 AWG 15A – 20A Circuit Breaker
Main Power Feed / Supply 10 – 12 AWG 30A – 40A Heavy-Duty Relay

Images References


Images References, Air Conditioner Troubleshooting 3

Looking for more diagnostic guides? Explore our complete Air Conditioner Troubleshooting 3 section for step-by-step troubleshooting solutions.

📚 Related Articles

Scroll to Top